What 7 × 9.25 in means
This preset reproduces the cited finished rectangle only. It does not copy branded artwork or assert disc-hole geometry.
The builder preserves these finished dimensions and will not silently scale the page to make an incompatible imposition fit.
Choose a source sheet and binding clearance
Center one Classic page on either A4 or US Letter, or print directly on paper cut to 177.8 × 234.95 mm. Two-up does not fit A4 because the 210 mm landscape cell height is shorter than 234.95 mm. It does not fit Letter because each cell is only 139.7 mm wide, less than the 177.8 mm page.
Centered and two-up files include crop marks where there is room outside the finished page. A mark is omitted where a source-sheet edge is already the finished edge; this does not change the page dimensions.
The inner content margin moves writing areas away from the selected binding edge. It is content clearance, not a punch-hole coordinate or a promise that a particular punch will fit. Trim first, then align the finished sheet with the punch maker’s physical guide.
Run one measured test
Download a one-page test before committing to a full run. In the print dialog, choose the paper named in your plan, turn off Fit or other scaling, and measure the calibration mark. A mathematically correct PDF cannot predict a printer driver, printable area, feed path, or borderless setting.
After trimming, measure width and height before punching. If the result is off, correct print scaling or the selected source sheet; do not compensate by guessing new page dimensions.